Installation guide
Connect to RJ45 port
1.Connect one end of RJ45 wire to switch, the other end to other equipment, as
shown as the figure on the right;
2.After power on, please check the LED indictor status. If it is on, it shows the
link is OK, otherwise, the link is down. Then please check the link and make
sure the other equipment is turned on, refer to the instruction on above page
for details.
Rj45 port
Plug
Connect to SFP port
Smart managed PoE switch has 2 independent SFP ports. Please refer to the following steps for optical module installation.
1.Grasp SFP module and insert it in switch SFP slot smoothly till they keep close contact;
2.Insert one end of the fiber to the Rx and Tx accordingly, and the other end to other equipment, shown as in the right figure;
3.After power on, please check the LED indictor status. If it is on, it shows the link is OK,
otherwise, the link is down. Then please check the link and make sure the other
equipment is turned on.
SFP Port
Fiber module
Optical Fiber
Connect to power
Smart managed PoE switch adopts AC 100-240V, 50/60Hz.
1.Please check the power supply specification matches with the required;
2.Connect switch power wire to AC power socket, shown as in the following figure.
Power Supply Connection Figure
Mounting Kits Installation Figure
Rack Installation Figure
L Angle Iron
Screw
After installation, please check:
If there is enough space for heat sink; if the power socket is suitable for switch specification; if the power, switch and rack are
properly grounded and if the connection between switch and other network equipments are normal.
