OnTruss Prinz Gewerbepark - Halle 78 Bozener Str. 1 86165 Augsburg / GERMANY
17 von 27
This is the initial position of the corner. There are 2 GripSlats (#1) in each groove. Both BoardBinders are
inserted in the short rails and are in rest position (#2). You have to open the two Velcro tapes (#3).
1.
Place the corner on both straight
boards.
Check that the
connection is flush.
2.
Move now both
BoardBinders.
It snaps into the corner
and the straight board.
3.
Fasten the Velcro tapes
on the truss pipe.
Pull the Velcro tape firmly.
The corner is correctly placed when both BoardBinders are in this position.
Finally, use the two Velcro tapes to fix the corner piece. Put the Velcro around the truss pipe, guide it
through the eyelet and tighten it hand-tight to the back.
.
Info: For easier handling of the BoardBinder you can use the BoardBinder ReleaseTool for other purposes. Insert the tool at a slight
angle to the intermediate position (imprinted with a short line) and then move the BoardBinder at this angle.
