Ontech GSM Mini 9009, User Manual

Page: 15 / 36

-15-
Status-SMS
You can ask for a status-SMS. In the SMS all settings will be reported as well as the
actual temperature.
Note that this cannot be done from an ordinary telephone, only from a mobile
phone.
Send an SMS to the unit with the following message:
ABCD#8# (ABCD is your PIN-code).
You will immediately receive an SMS. The message is interpreted as follows:
Example Explanation
*Ontech9009 A star (*) means that the alarm function is turned on.
Alarm:
1ab, 3b Indicates all alarms that have been activated since the last
acknowledge. The number indicates the unit, Ontech 9009 is
always no 1, and the others refer to the slaves unit connected.
See page 20.
Note that these inputs not can send an alarm again before the
alarm has been acknowledged.
Inputs:
1b Indicates the alarm input that still is activated. In this example
the SMS means that inputs 1a, 1b and 3b has been activated
since the last acknowledge and that input 3b still is activated.
Units:
1*,3,4* Indicates the units communicating with the master unit. Unit
number 1 is always the master unit. The other numbers refers
to the slave units connected. A star (*) after the number
indicates that the relay is turned on.
If the master looses contact with one of the slaves unit its ID
number will not be shown in the SMS.
Alarmrelay on Indicates that the ALARMRELAY function is activated.
Temp watch on Indicates that the Temperature guard function is activated.
Temp:24 Gives the temperature at the master unit in degrees Celsius.