Protective Case
Page 5 of 6
Mounting
You can mount the case to a wall or other location for a permanent installation with or without the
mounting feet included with the case. This section explains the two methods for mounting the case. Note:
The diagrams in this manual show the case with the mounting feet already attached.
Items required
•
If using mounting feet: Slotted screwdriver and mounting kit provided with the case, which
includes two mounting feet, two short flat-head screws and two long Phillips-head screws
•
If not using mounting feet: Phillips-head screwdriver and four Phillips-head screws provided with
the case
Mounting instructions
To mount the case with the mounting feet:
1.
With a slotted screwdriver, screw the mounting feet onto the back of the case using the two short
flat-head screws in the mounting kit provided with the case. There are two holes pre-drilled on
the back of the case for attaching the feet.
2.
Once the feet are attached, screw the two longer screws through the holes in the mounting feet to
the wall (or other location).
To mount the case without the mounting feet:
1.
Remove the clear cover from the case.
2.
There are four openings next to each of the four screw holes used to attach the clear cover (as
shown in the illustration below). Screw in the four Phillips-head screws through the inside of the
case to the wall (or other location).
3.
Replace the clear cover.
Openings for
mounting screws
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
