24
Initial Setup
Initial Setup with Auto Start-up Wizard
Initial Setup Starts Automatically
When you turn the unit on for the first time after purchasing
it, Initial Setup is automatically shown on the TV to enable
you to make settings required for startup using simple
operations following onscreen guidance.
1. Switch the input on the TV to that assigned to the unit.
2. Put batteries into the remote controller of this unit.
3. Press
Í
on the remote controller to turn the unit on.
4. Select the item with the cursors of the remote controller
and press ENTER (a) to confirm your selection. To return
to the previous screen, press
(b).
0
If you terminate the procedure on the way or want to
change a setting made during Initial Setup, press
on
the remote controller, select "7. Miscellaneous" – "Initial
Setup", and press ENTER.
∫
1. AccuEQ Room Calibration
Place the supplied speaker setup microphone in the listening position,
measure the test tones emitted by the speakers, then the unit
automatically sets the optimum volume level for each speaker, the
crossover frequencies, and the distance from the listening position. This
also automatically adjusts the equalizers for the speakers and enables
correction of distortion caused by the acoustic environment of the room.
0
Calibration takes between 3 and 12 minutes to be completed.
The speakers emit the test tone at high volume during
measurement, so be careful of your surroundings. Keep the
> Install
> Playback
Troubleshooting | Supplementary Information, etc.
1
2
3
TV
INPUT
a
b
Summary of Contents for TX-RZ820
Page 35: ...35 En ...
