En
9
> Before start
> Hookup
> Setup
> Playback
> Part Names
Step2: Connect the Speakers
2
1
1/2˝
(12 mm)
1
Speaker cable,
2
Subwoofer cable
in case of:
Pages 3 to 7
Connect
123456
for a 5.1-channel system. For a
7.1-channel system, select either surround back speakers
or height speakers, and connect
78
. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER jacks.
Make sure the exposed wires of the speakers do not stick out of
the speaker terminals when connecting. If the exposed wires of
the speakers touch the rear panel or the + and – wires touch each
other, the protection circuit will be activated.
Setup
0
The speaker configuration is set to
123456
78
audio output by default. If there
are speakers you won't be connecting, you need to
change the settings in Initial Setup, "1. AccuEQ
Room Calibration" (
Ä
P18) so that the audio from
those speakers you are not connecting is sent to
other speakers.
SN29402171_TX-RZ610_BAS_En_1602xx.book 9 ページ ２０１６年２月４日 木曜日 午後１時４４分
