TX-NR1030/3030/ PR-SC5530/ DTR-60.6/70.6/ DHC-80.6
OPERATION CHECK-5
CONFIRMATION OF FL TUBE AND LED
1. Do the following operation.
2. Confirm that all LEDs and all segments of FL tube are lit.
[TV/CD] + [ON/STANDBY] → [DIMMER]
CONFIRMATION OF HEAD PHONE OPERATION
Confirm the headphone mark when headphones plug is inserted into the PHONES jack.
CONFIRMATION OF FM RADIO OPERATION
1. Setting of Signal Generator(SG)
Carrier frequency
any
Modulation
1kHz
Deviation
75kHz
Output level
35dBu
2. Waveform confirmation
Set the signal of SG as following channels and confirm output is the following table.
SG Input
Lch
R ch
(1) R ch only
No
Yes
(2) L + R ch
Yes
Yes
3. Confirmation of Stereo indicator
Set SG as stereo and confirm stereo indicator is on.
4. Confirmation of Auto stop operation
Do auto tuning (Press TUNING UP or TUNING DOWN button) and confirm that the searching stops when a station that
is set by SG is found.
Output
CONFIRMATION OF RDS (RADIO DATA SYSTEM) OPERATION (Applied to MPP/MPB/MM* type )
1. Input 98MHz,30dBμ signal modulated with RDS data.
2. When a PS information is received, the name of the station "RDS TEST" shall be displayed within 2 seconds
instead of the frequency.
CONFIRMATION OF OSD(ON SCREEN DISPLAY) OPERATION
1. When HOME button is pushed, confirm that setup menu is displayed in HDMI Out.
2. Confirm that specified operations for ENTER(with 4-cursor) buttons are made.
CONFIRMATION OF CEC OPERATION
1. Connect AVR's HDMI OUT to HDMI input of appliance compatible with CEC(SINK or REPEATER) by HDMI cable.
2. Turn on the power to the AVR
FL tube will display "OK" or "NG".
to the following test mode.
TEST 6-00
3-2.
[TV/CD] + [ON/STANDBY] → [AUX]
3-1. set the volume level to
30
3. Do the following operation.
1. Press TEST TONE on remote controller then press CH SELECT repeatedly.
Set turn to Dolby Test mode tone Check speaker condition.
2. Please check that a sound comes out from each channel.
-> FL ch -> C ch -> FR ch -> SR ch -> SBR ch -> SBL ch -> SL ch -> SW ch ->
CONFIRMATION OF DOLBY TEST TONE