3
Precautions
1. Warranty card
You can find the serial number on the rear panel of this
unit. In case of warranty claim, please report this number.
2. Recording Copyright
Recording of copyrighted material for other than
personal use is illegal without permission of the
copyright holder.
3. AC Fuse
The fuse is located inside the chassis and is not user-
servicable.
If power does not come on, contact your Onkyo
authorized service station.
4. Care
From time to time you should wipe off the front and
rear panels and the cabinet with a soft cloth. For
heavier dirt, dampen a soft cloth in a weak solution of
mild detergent and water, wring it out dry, and wipe off
the dirt. Following this, dry immediately with a clean
cloth. Do not use rough material, thinners, alcohol or
other chemical solvents or cloths since these may
damage the finish or remove the panel lettering.
5. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST
TIME, READ THE FOLLOWING SECTION
CAREFULLY.
• The voltage of the available power supply differs
according to country or region. Be sure that the
power supply voltage of the area where this unit will
be used meets the required voltage (e.g., AC230V
50Hz or AC120V 60Hz) written on the rear panel.
• Models Equipped with a Voltage Selector
Worldwide models are equipped with a voltage
selector to conform to local power supplies. Be sure
to set this switch to match the voltage of the power
supply in your area before plugging in the unit.
Setting the voltage selector
SKW-205
VOLTAGE
SELECTOR
220-230V
120V
VOLTAGE
SELECTOR
220-230 V
120 V
Setting the voltage selector
1. Determine the proper voltage for your
area: 220-230V or 120V.
2. If the preset voltage is not proper for
your area, insert a screwdriver into the
groove in the switch. Slide the switch
all the way to the lower (120V) or to
the upper (220-230V) whichever is
proper.
