4
En
The AV receiver allows you to update the
firmware using a USB device.
Note
• Make sure the AV receiver and TV are turned on.
• Never unplug or turn off the AV receiver during
the update process.
• Never plug or unplug an HDMI cable or a USB
device during the update process.
• Never unplug the USB storage device containing
the firmware file or the AC power cord during
the update process.
• Do not attempt to access the AV receiver from
your PC while it is being updated.
• It takes maximum 60 minutes to complete the
firmware update.
• The AV receiver will retain all your settings after
the update is finished.
Before you start
• Set the “
HDMI Control (RIHD)
” setting to
“
Off
”.
• Turn off the controller device connected via
RS232C and via Ethernet network.
• Turn off Zone 2 and Zone 3.
• Stop playback of contents from Internet
Radio, iPod/iPhone, USB or servers, etc.
• If there is any data in the USB device,
remove it first.
■
How to turn off HDMI Control(RIHD)
Update procedure
Updating the Firmware via
USB
1
Press
RECEIVER
followed by
SETUP
on the remote controller.
2
Select “Hardware Setup” and press
ENTER
.
3
Select “HDMI” and press
ENTER
.
4
Set “HDMI Control(RIHD)” to “Off”.
1
Connect a USB device to your PC. If
there is any data in the USB device,
remove it first.
2
Download the firmware file from the
Onkyo web site. The file name is as
follows:
ONKAVR****_************.zip
Unzip the downloaded file. The
following three files are created:
ONKAVR****_************.of1
ONKAVR****_************.of2
ONKAVR****_************.of3
3
Copy the extracted files to the USB
device. Be careful not to copy the zip
file.
4
Remove the USB device from your PC
and connect it to the
USB
port on the
AV receiver.
When the AV receiver has two USB
ports, you can use either one.
5
Make sure the AV receiver and TV are
turned on.
If the AV receiver is in standby mode,
press
8
ON/STANDBY
on the AV
receiver to light up the front display.
6
Select the USB input source.
“
Now Initializing...
” is displayed on the
front display and then the name of the
USB device is displayed. It takes 20 to
30 seconds to recognize the USB device.
7
Press
RECEIVER
followed by
SETUP
on the remote controller.
The setup menu will be displayed on the
TV screen. The procedures thereafter can
also be performed on the AV receiver by
using its
SETUP
, arrow and
ENTER
buttons.
