Onkyo HTP-993 Manual Download Page 4

En-4

Powered Subwoofer (SKW-980: North American 
models/SKW-938: European models)

Front Speakers (SKF-980)

Center Speaker (SKC-980)

Surround Speakers (SKR-980)/
Surround Back Speakers (SKB-980)

Specifications and appearance are subject to change 
without prior notice.

THX and the THX logo are trademarks of THX Ltd., 
registered in the U.S. and other countries.

Use with a TV set

In general, Braun tubes used for color television sets, etc. 
are extremely sensitive and can be affected even by the 
magnetism of the earth. If a speaker system is used near 
them, therefore, discoloring or distortion of pictures will 
occur.

For magnetic shielded speakers (Front speakers, Center
speaker):

The speakers are shielded to prevent discoloration. In some 
situations, however, discoloration may still be an issue, in 
which case you should turn off your TV or monitor, wait 
15 to 30 minutes, and then turn it back on again. This 
normally activates the degaussing function, which 
neutralizes the magnetic field, thereby removing any 
discoloration effects. If discoloration problems persist, try 
moving the speakers away from your TV or monitor.

For non-magnetic shielded speakers (Powered 
subwoofer, Surround speakers, Surround back 
speakers):

Try moving the speakers away from your TV or monitor. If 
discoloration should occur, turn off your TV or monitor, 
wait 15 to 30 minutes, and then turn it back on again. This 
normally activates the degaussing function, which 
neutralizes the magnetic field, thereby removing any 
discoloration effects.

Specifications

Type

Acoustic suspension

Rated output power 
(FTC)

125 watts minimum continuous power,
6 ohms, driven at 100 Hz with a maximum 
total harmonic distortion of 1% (SKW-
980)

Rated output Power 
(IEC)

125 watts minimum continuous power, 
6 ohms, driven at 100 Hz with a maximum
total harmonic distortion of 1% (SKW-
938)

Input sensitivity/
impedance

280 mV/20 k

Frequency response

20 Hz to 100 Hz

Cabinet capacity

49 L (1.73 cubic feet)

Dimensions (W

 × 

H

 × 

D)

380 mm × 444 mm × 429 mm
14-15/16" × 17-1/2" × 16-7/8" 
(incl. grille and projection)

Weight

15.5 kg (34.2 lbs.)

Drivers unit

30 cm (12") Cone Woofer

Power supply

AC 120 V, 60 Hz (SKW-980)
AC 230 V, 50 Hz (SKW-938)

Power consumption

140 W (SKW-980)
137 W (SKW-938)

Grille

Fixed

Other

Auto Standby function
Non-magnetic shielding

Type

2 Way Acoustic suspension

Impedance

Maximum input power



W

Sensitivity

83 dB/W/m

Frequency response

50 Hz to 45 kHz

Crossover frequency

2 kHz

Cabinet capacity

7.5 L (0.265 cubic feet)

Dimensions (W

 × 

H

 × 

D)

158 mm × 433 mm × 199 mm
6-1/4" × 17-1/16" × 7-13/16"
(incl. grille and projection)

Weight

5.3 kg (11.7 lbs.)

Drivers unit

12 cm (5") A-OMF Cone Woofer × 2
2.5 cm (1") Soft Dome Tweeter × 1

Terminal

Binding post (Banana type supported)

Other

Magnetic shielding

Type

2 Way Acoustic suspension

Impedance

8

Maximum input power

130 W

Sensitivity

83 dB/W/m

Frequency response

50 Hz to 45 kHz

Crossover frequency

2 kHz

Cabinet capacity

7.5 L (0.265 cubic feet)

Dimensions (W

 × 

H

 × 

D)

433 mm × 158 mm × 199 mm 
17-1/16" × 6-1/4" × 7-13/16" 
(incl. grille and projection)

Weight

5.3 kg (11.7 lbs.)

Drivers unit

12 cm (5") A-OMF Cone Woofer × 2
2.5 cm (1") Soft Dome Tweeter × 1

Terminal

Binding post (Banana type supported)

Other

Magnetic shielding

Type

2 Way Acoustic suspension

Impedance

8

Maximum input power

130 W

Sensitivity

81 dB/W/m

Frequency response

50 Hz to 45 kHz

Crossover frequency

2 kHz

Cabinet capacity

4.6 L (0.163 cubic feet)

Dimensions (W

 × 

H

 × 

D)

200 mm × 275 mm × 169 mm
7-7/8" × 10-13/16" × 6-5/8"
(incl. grille and projection)

Weight

3.5 kg (7.7 lbs.)

Drivers unit

13 cm (5-1/8") A-OMF Cone Woofer × 1
2.5 cm (1") Soft Dome Tweeter × 1

Terminal

Binding post (Banana type supported)

Other

Non-magnetic shielding

SN29402382_HTP-993_EnFrEs_1703xx.book  4 ページ  2017年3月17日 金曜日 午後2時58分

Summary of Contents for HTP-993













Reviews: