Solution:
Replace pickup connector cable. "Second time around".
Fig6
Fig7
Fig8
Front and rear panel removed
Pull carousel forward with latch
pushed down.
Latch
Carousel removed
You may disconnect cable from
P111B
Remove two PCB mounting screws
and short pickup LD terminals.
Connect cable PN#2042184012
directly to the pick-up. Please pay
attention to the BLUE BACK.
Bend the new cable
PN#2042184012 at the point of red
marking towards the marking.
Re-assemble the unit back
and attach the cable as
illustrated next Fig14. It is
important to keep the pickup
shorted until last.
Bend cable as you see on this
picture. Please do not crush cable.
Make sure the cable at
connector CN501 is curled to a
minimum to avoid cable break.
Fig9
Fig10
Fig11
Fig12
Fig14
Set the unit on its side and de-solder the
shorting from the pick up very carefully.
Fig15
Core PN#
230957
must be
installed at this point using
double side tape.
The bend seen in Fig11 shall match this corner
(white mark). Return the clear vinyl as it was.
Use double side tape to attach cable.
Fig13
