9/28
<Composite Video Output BNC
⑨
Connector>
Connect a video cable to the SIGNAL OUT connector (BNC) on the back of the camera.
75 ohms impedance composite video signal output.
Connect the video output jack to the monitor video input jack.
<Power Terminal Connector
⑬
>
24V AC/12V DC
----
Use the class2 isolated supply only.
Connect the power cable to the two-pin power connector on the back of the
camera using the terminal block connector.
FG
---
Frame GND. Connect the Earth.
*. Connecting method for AC power type : The wire is no polarized. / Use 24V AC 60Hz(NTSC),
use 24V AC 50Hz(PAL).
Connecting method for DC power type : The wire is no polarized. / Use 12V DC.
*. Be sure to connect power after all the installation has been done.
Note that AC adapter is not supplied with camera.
Class2
Isolated Power
Supply
(24V AC or 12V DC)
FG
*. If the camera power is offered through the UTP cable than the camera power selects
to “UTP” position. Refer to the section on “Camera Power Select Switch”.
<Power LED
⑭
Indicator>
LED (RED
)
----
The LED on the back panel of camera indicates that power is connected.
Power and Video Connections
Pin NO
Name
Description
1
Video +
UTP Transmitted video
2
Video -
UTP Transmitted video signal -
3
Rx+ or Tx+
Control Data RS485 (or Trans+) data
(For ONS-620 HQ1 OSD Series only)
4
GND or 24~28V AC-
Power GND or AC power -
5
12-48V DC or 24~28V AC+
12-48V DC or 24V-28V AC Power Supply input
Rx- or Tx-
12-48V DC or 24~28V AC+
GND or 24~28V AC-
6
Control Data RS485 Receive- (or Trans-) data
(For ONS-620 HQ1 OSD Series only)
7
12-48V DC or 24V-28V AC Power Supply input
8
Power GND or AC power -
<RJ-45 Modular JACK
⑧
for UTP cable>
Summary of Contents for ONS-620N HQ1 Dual OSD
Page 27: ... unit mm 27 28 Dimensions ...