12
Liquid may be HOT, release pressure before servicing.
Pump should only be serviced by qualified personnel. Make sure to
prime pump before operating. NEVER run pump dry!
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised service agent.
SERVICE & MAINTENANCE (continued)
4.
Dispose of cardboard washer. If need ensure polished surface of seal
seat is free of dirt and has not been damaged during insertion. Remove
any excess lubricant that may have been dislodged during insertion and
ensure that there is no lubricant on the polished face of the seal.
INSTALLATION OF ROTATING PART OF SEAL UNIT
(Figure D)
2.
Reinstall seal plate using extreme caution not to hit ceramic portion of
seal on motor shaft.
3.
Inspect shaft to ensure that it is clean.
1.
Clean face of sealing washer with clean cloth.
4.
Lubricate outer face of rubber drive ring with silicone-based lubricant,
ensuring no lubricant touches the polished face, and slide assembly on
motor shaft (sealing/polished face first) until rubber drive ring hits shaft
shoulder (ensure that the polished face does not hit the motor shaft).
5.
Screw impeller on shaft until impeller hub hits shaft shoulder. This will
automatically locate seal in place and move the sealing washer face up
against the facing seat.
Should you have any difficulty replacing the seal unit please contact your local
pump professional.
L100100_400Series_OM
Wednesday, 13 March 2013 9:13:39 AM
