6.
Never disassemble or pierce the product in any way. Otherwise, it may leak, catch on fire, or explode.
7.
DO NOT use the product if it was involved in a crash or a heavy bump.
8.
If the product falls into the water during use,take the product out immediately and put it in a safe and open area.
Keep a safe distance from it until it is completely dry. Never use it again and dispose it properly as described in the
Battery Disposal section below. If the product catches fire, it is recommended to use fire extinguishing equipment in
the following order: water or water mist, sand, fire blanket, dry powder, carbon dioxide fire extinguisher.
9.
DO NOT put the machine in a microwave oven or in a pressurized container.
10.
DO NOT allow pins, wires or other metal pieces to insert to the device case, outlets or controls. Metal pieces may
short circuit the product.
11.
Avoid collision. DO NOT place heavy objects on the machine.
12.
If there is dirt on any plug or outlet surface, use a dry cloth to clean it. Otherwise, it will cause abrasion and result in
energy loss or inability to charge.
1.
Dispose the product in specific recycling boxes only after a complete discharge. Batteries are hazardous chemicals.
Please strictly follow your local regulations regarding the battery disposal and recycle.
2.
Dispose of the product immediately if it cannot be powered on after over-discharging.
Battery Disposal:
WARNING
Product Charging:
1.
Keep the product out of the reach of children. If any children accidentally swallow parts, please go to a doctor immediately.
2.
If a low-battery warning appears, charge the battery before store it. Otherwise, long-term storage may cause damage to the
battery in the product. Batteries in the product will enter hibernation mode if it is depleted and stored for a long time.
Recharge the product can bring the battery out of hibernation.
3.
DO NOT place the product near a heat source, such as a car in direct sunlight, a fire source, or a heating stove.
4.
Store the product in dry environments. DO NOT place the product where it may contact with water.
5.
Make sure no small metal objects can fall on or around the product while in storage.
6.
Never ship a product with a battery power level higher than 30%.
Product Storage and Transportation:
1. Always use ONEUP approved charging cables. ONEUP takes no responsibility for any damage caused by using
non-ONEUP charging cable.
2. When charging, please place the product on the ground with no flammable or combustible materials around. To
prevent accidents, never leave the machine unattended during charging.
3. DO NOT charge a product immediately after a long heavy load, because the product’s temperature may be too high.
DO NOT charge a product until it cools down to room temperature. The product may be unable to charge out of the
temperature range 32ºF to 113ºF (0 to 45°C). The ideal charging temperature range is 71ºF to 82ºF(22°C to 28°C).