- 10 -
Diagram 8
Scrap and disposal:
When the battery is end of life, an intermittent “chirp” with
red LED flashes once every 40 seconds: indicates that the
smoke alarm device is low battery. Please scrap it according
to below following the steps and immediately buy another
new alarm to replace it.
• Counter clockwise remove the product from bracket.
• Take out the screws with a slotted screwdriver and remove
smoke alarm from the bracket.
• Insert a slotted screwdriver into red plastic part on the base
cover (Refer to Diagram 9).
• Rotate a screwdriver from the ON position to the OFF
position counterclockwise.
• At this time, a red LED light up and indicating that the
battery is discharging.
• Wait for at least one day. , allow that the battery inside the
product is fully exhausted. You can scrap and dispose it
according to the local law.
Note
:
1.
When a red LED is off, it does not mean that the battery is
exhausted, Must also allow the battery to fully discharge
for at least one day.
2.
Use this method to scrap the alarm if the is the end of life
during out of warranty.
3.
Please return to retailer and change another alarm during
the Warranty.
4.
Cannot install the smoke alarm again once he battery is
discharged
Diagram 9
SERVICE AND WARRANTY
Company warrants to the original consumer. Purchase each
new smoke alarm to be free from defects in material and
workmanship under normal use and service for a period of 3
years from the date of purchase. This warranty does not
cover damage resulting from accident, misuse or abuse or
lack of reasonable care of the product. In no case shall
company be liable for any incidental or consequential
damages for breach of this or any other warranty express or
implied
，
whatsoever. The bad product can be mailed to the
following address with a detail explanation of problem.
If after reviewing this manual you feel that your smoke alarm
is defective in any way, do not tamper with the unit. Return it
for servicing to:
800.607.054
1
|
31100 Solon Rd STE 16 Solon, OH 44139
