ASSEMBLY INSTRUCTIONS (50-CS03)
8 of 10
STEP 3
STEP 4
Insert two Screws (C) through the Right Leg (6) and the Left Frame (12) and attach to the Upper Crossbars (14). Using the other
two Screws (C) do the same with the Side Stand Leg (16) and the Right Frame (11). Rotate the Upper Crossbars so that the
screw holes are facing up and down.
Attach the Side Stand Top (2) to the Upper Crossbars (14) with four Screws (
I
).
K
K
13 (no screw holes
in the middle)
2
6
16
Cx4
Dx8
I
x4
C
D
D
D
C
I
I
14 (with holes)
11
12
NOTE: The Upper Crossbars (14) have holes in the middle to attach to the Side Stand Top. The Lower Crossbars (13) do not.
Attach the Left (12) and Right (11) Drawer Frames to the two Lower Crossbars with four Screws (D). Use the outer screw holes
at the bottom corners of each frame.
With the remaining screw holes at the bottom of the frames, use two Screws (D) to attach the Left Frame (12) to the
Right Leg (6) of the desk (this leg is on the
left
in the drawing below) and two more Screws (D) to attach the Right Frame (11)
to the Side Stand Leg (16).
