8
Mini-Gorilla Owner’s Manual O.A.S. 2010
c
Assembly Instructions with the Mobile Cart
7. Cyclone should be mounted to mobile stand. Carefully,
with help, flip cyclone cone right-side up and proceed with
assembly of Motor / Fan Wheel to the top of the Cyclone
using the instructions from the previous page.
5. Put wheel through front tab on bottom of tray then reas-
semble wheel unit with washer, PVC spacer, Rubber spacer
and knurled nut. Tighten nut to expand rubber spacer so wheel
fits snugly in front leg.
6. Put assembly in leg then tighten nut above tab with wrench
to tighten wheel in leg.
Front wheel assembly.
Wheel
Washer
Knurled
Metal Nut
Gray PVC Spacer
Black Rubber Spacer
1. Start with Cone. Do not attach motor until the cart is fully as-
sembled.
3. Put end cap on axle then put on wheel / washer / through
the eye bolt / washer then through the tubes on the bottom
of the tray as shown in diagram below, then repeat on the
other side.
2. Before you attach the legs to the bracket, you must put end
caps in all of the legs. To do this, start with the front bent leg.
Screw an eye bolt into the end cap as shown above then gently
with a hammer, hit the eye bolt to force the end cap evenly into
the leg end until it is flush and centered. Remove the eye bolt
from the front leg and repeat this procedure with the straight
back legs, leaving the bolts in the end caps. The axle goes
through the back leg eye bolts.
Using the provided longer bolts, attach the legs to the brackets,
then put the bracket and leg on the underside of cone ring as
shown and attach with the shorter bolts. Make sure the bent leg
is in front and the straight legs with the eye bolts are in the back.
End Cap
Wheel
Washers
Eye Bolt / Leg
Tray
Axle
Bent Front
Leg
Eye
Bolts
Eye Bolt &
End Cap
