OneAccess One80XM, Installation Manual

Page: 36 / 47

One80XM Chapter 6
Installation Guide Installing the One80XM
36
6.3 Mounting the One80XM on a Wall
Procedure
The bottom plate of the One80XM has 2 mounting holes in order to enable wall mounting. Refer to the
figure below, for the position of these notches. By installing two screws at the required distance, the
router can be hung on any vertical surface.
In order to do so, proceed as follows, also refer to the figures below:
Step Action
1 Drill two holes in the wall, according to the following specifications:
• hole diameter: 6 mm
• distance between the holes: 160 mm
• hole depth: at least 50 mm
2 Insert two standard wall plugs in the holes. The plugs should have the following dimen-
sions:
• diameter: 6 mm
• length: < 50 mm
3 Screw in two standard screws in the plugs. Leave a distance of 5 mm between the wall
and the head of the screw. The screws should have the following dimensions:
• diameter: 4 mm
• length: 40 mm
• The head of the screws may have a diameter of maximum 8 mm.
4 Slide the One80XM over the screws until it touches the wall, and gently push it down. If
necessary, adjust the screws in the notches of the router.