ONE Cartridge Tank Filters, Installation Instructions & Owner'S Manual

Page: 11 / 16

11
4. Remove top cap of system by lifting up on top handles (see photo to right) .
5. Remove replacement cartridge carefully from bag. Retain bag for disposal of
used cartridge.
6. Remove used cartridge from system by grasping handle and pulling upward while
holding the tank down (see photo to right) . Place in bag and dispose of in
accordance with local, state and federal laws and regulations.
7. If necessary, open drain and flush system further with a bucket of water
to remove final sediment and particles. Once flushed, close drain line.
TROUBLESHOOTING GUIDE:
Lack of pressure
from system
A. Cartridge fouled out A. Replace cartridge
B. Exceeded flow rate of cartridge B. Substitute cartridge for higher flowing unit
C. Inlet to tank is plugged C. Clean inlet of debris
Cartridge life too short
A. Too small micron rating A. Choose different size or use multiple tanks
B. Very heavy loading B. Check raw water for particles
C. Excessive water flow through cartridge C. Check gallons consumed
Plugged drain A. Not flushed often enough A. Flush more frequently
Water leak at
depressurization button
(EF-835-2 only) A. O-ring leak A. Replace depressurization button
PROBLEM CAUSE CORRECTION
REPLACEMENT CARTRIDGES:
EF-835-1 REPLACEMENT CARTRIDGES
Part No. Description Qty.
CT-1005 10 x 5 Micron Double Pleated 1
CT-2010 20 x 10 Micron Double Pleated 1
CT-5020 50 x 20 Micron Double Pleated 1
CT-2005-SWMB 20 x 5 Micron String Wound/Meltblown 1
CT-5020-SWMB 50 x 20 Micron String Wound/Meltblown 1
CT-03-CB 3 Micron Carbon Block 1
CT-20-CB 20 Micron Carbon Block 1
EF-835-2 REPLACEMENT CARTRIDGES
Part No. Description Qty.
CT-P1A 1 Micron Absolute Pleated Polypropylene 1
CT-P05 5 Micron Pleated Polypropylene 1
CT-P20 20 Micron Pleated Polypropylene 1
CT-ACP Pleated Activated Carbon Polypropylene 1
CT-D05 5 Micron Meltblown Polypropylene 1
CT-D20 20 Micron Meltblown Polypropylene 1