10
INSTALLATION OF NEW CARTRIDGE
1. Remove cap from cartridge tank
(see Removal of Cartridge, steps 1-3)
and then push top cap
down equally with both hands to unseat retaining ring. Remove ring from groove by carefully grasping
handle and pulling inward then upward. Ring will slide completely out of groove.
2. Remove top of cap from system by lifting up on top handles
(see photo to right)
.
3. Remove plastic covering surrounding filter cartridge and discard.
4. Lubricate O-rings on cartridge to ensure proper sealing.
Do not use pipe dope,
Vaseline, oils or other unacceptable lubricants on O-rings.
Food grade silicone
lubricant is recommended.
5. Insert cartridge into bottom center of tank, assuring proper seal and alignment
by pushing down gently until fully seated
(see photo to right)
.
6. Attach product description tag to retaining ring handle for future reference
(see photo to right)
.
NOTE:
This tag is found on the new cartridge handle.
7. Replace top cap of tank using top handles.
8. Push top cap down to make room for placement of retaining ring in
ring groove.
9. Insert retaining ring into ring groove, starting at the end opposite of the
handle. Using only hands, gently push retaining ring into groove until entire
ring is in place and both ends meet in groove section
(see photo to right)
.
10. To ensure proper engagement, hold retaining ring by handle and slightly rotate around inner diameter
of vessel.
11. Slowly turn water supply on to system by first opening inlet valve and pressing red depressurization
valve to completely vent tank of trapped air; when water leaks out of depressurization valve, stop
pushing and open outlet valve.
12. Check system for leaks and ensure system integrity.
REMOVAL OF OLD CARTRIDGE
1. Turn off water supply to system by shutting off inlet and outlet valves.
2. Properly depressurize system by pushing red depressurization button on top cap of system. Keep button
pushed until all air or water pressure is completely released.
3. Push top cap down equally with both hands to unseat
retaining ring. Remove ring from groove by carefully
grasping handles and pulling inward then upward.
Ring will slide completely out of groove
(see photos
to right)
.
CARTRIDGE REPLACEMENT INSTRUCTIONS FOR EF-835-2:
Summary of Contents for Cartridge Tank Filters
Page 1: ...ONE Cartridge Tank Filters ...
Page 8: ...8 ...
