One Stop Systems, Inc. Host Cable Adapter User Manual
Rev. A
4
Installing the Host Ca
Host Cabl
sure that the card is well seated, and
t aligned with the key ridge of the Host
Cable Adapter
nnector on the board until the cable locks in
. The connectors on either e
nector is equipped with a retractor to allow
the connector to be locked into place.
tor
on
Cable
Connector
4. Attach the other end of the cable to the cable port connector of the HIB2, HIB4, or PCI Express switch depending on
your SuperSwitch configuration
.
Removing the Host Cable Adapter
:
1.
pulling on the green retractor ring which releases the locking mechanism.
2.
e screw before removing the Host Cable Adapter from the card slot.
pecifications
ble Adapter
:
e Adapter into a PCIe x8 or x16 add-in card slot. Make
slot cover, insert the cable connector into the cable port co
nd of the PCIe x4 cable are identical. Each con
1. Insert the
tighten the screw.
2. Attach the cable by first pulling back on the retractor ring. With the keyed slo
place.
3
Retrac
Retractor ring
Remove the cable by
Loosen and remove th
S
Electrical/Mechanical Specifications
Form Factor: PCIe x8 add-in card
Dimensions (H x L): 4.3773 x 5.135 inches (101.6 x 130.4 mm)
Front Panel Connectors: Two or four PCIe x4 cable connectors
Front Panel Indicators: Cable Port Status LEDs (one for each connector)
Power Consumption (designed to meet the following conditions
6.5W maximum (3.2W @ 3.3V, 3.3W @ 12V)
Operating Environment (designed to meet the following conditions)
Temperature Range: 0° to 50°C (32° to 122°F)
Relative Humidity: 10 to 90% non-condensing
Shock: 30g acceleration peak (11ms pulse)
Vibration: 5-17 Hz 0.5” double amplitude displacement; 7-2000Hz, 1.5g acceleration.
PCI Express Switches
PLX PEX8525
Agency Compliance Designed to meet, but not tested
UL60950, FCC Class B, CE safety and emissions
Alignment
grooves
