Description
The Host Cable Adapter (Part # OSS-PCIe-HIB2-x4-H) allows communication between a processor and an I/O port. The OSS-
PCIe-HIB2-x4-T is used as a target in a One Stop Systems 2 slot backplane (OSS-EBP-2000).
2.713"
2.713"
3.35"
Slot Cover
(also available
in low profile
height
)
Power on /
Cable Ready
LEDs
PCIe
x4
Connector
Initial Set-Up
Unpacking Instructions
1. If the carton is damaged when you receive it, request that the carrier's agent be present when you unpack and inspect
the equipment.
2. After unpacking, verify that all items listed in the packing list are present.
3. Inspect the equipment for shipping damage.
4. Save all packing material for storage or return shipment of the equipment.
5. For repairs or replacement of equipment damaged during shipment, contact One Stop Systems, Inc. to obtain a
Return Materials Authorization (RMA) number and further shipping instructions.
Installation and Removal
1. Power down the host system.
2. Open the chassis according to your system documentation.
3. Let the power supply cool down, if necessary.
4.
Remove the Host Cable Adapter from the protective bag, observing proper ESD safety procedures
.
Installing the Host Cable Adapter
:
1.
Insert the Host Cable Adapter into a PCIe x4, x8 or x16
1
add-in card slot. Make sure that the card is well seated and
tighten the screw.
One Stop Systems, Inc. Host Cable Adapter User Manual
Rev. A
2
1
“
Up-plugging” the Target Cable Adapter into a x8 or x16 slot is allowed, but the motherboard manufacture may limit the bandwidth to x1 (250MB/s)
speeds. If you need to do this, check with the motherboard manufacturer to see how up-plugging is handled on their motherboards. A PCIe x4 board
will not physically fit in a x1 slot.
