SKU 92508 For technical questions, please call 1-800-444-3353.
PAGE 7
OPERATION INSTRUCTIONS
Figure 3
View from underneath the Base (1).
MAINTENANCE INSTRUCTIONS
SENSITIVITY Setting
This controls the amount of motion
needed to trip the sensor and the distance
that the sensor detects motion at. Keep in
mind that the motion sensor’s range is
approximate and many different factors
can affect the range that this unit detects
motion at.
Turn the dial clockwise to increase the
sensitivity and counterclockwise to make the
unit less sensitive.
Refer to Figure 3 on the right for the
location of the different settings.
TIME Setting
This controls the amount of time that the
light stays on when the sensor is tripped.
Turn the dial clockwise for more time (up
to 5 minutes) and counterclockwise for less
time (down to one minute).
MODE Settings
TEST
This mode leaves the lantern on con-
stantly and illuminates the red light on
the control panel if the unit detects mo-
tion. This setting is helpful for adjusting
the sensitivity.
PHOTO
This mode switches the lantern on when
darkness falls.
SECURITY
This mode illuminates the lantern for the
duration set by the TIME setting when-
ever the sensor detects motion.
Shut the unit off at the wall switch before
performing any maintenance, or inspection
procedures, or before changing the light bulb.
1.
Inspect the unit periodically. Check for
loose mounting, breakage of parts, and
any other condition that may affect the
lantern’s operation. If damaged, have the
lantern serviced before use. Many acci-
dents are caused by poorly maintained
fixtures.
2.
Weekly, wipe the lantern and sensor off
with a damp cloth.
3.
To Change The Bulb:
A. Shut off the switch and wait until the
lantern has cooled off.
B. Remove the Hood Nut (4) and the
Hood (3).
C. Loosen and remove both Nuts (7).
D. Remove both Washers (6) and the
Hood Bracket (5).
E. Using protective gloves, remove the
old bulb and install a new type A bulb
of 100 watts or less.
F. Reassemble the lantern securely.
