background image

Page 5

For technical questions, please call 1-800-444-3353.

Item 69462

maintenance

Read the entiRe impoRtant SaFety inFoRmation section at the 

beginning of this document including all text under subheadings therein 

before set up or use of this product.

to pRevent SeRiouS injuRy FRom tool FailuRe: 

Do not use damaged equipment.  if abnormal noise or vibration 

occurs, have the problem corrected before further use.

1.  Clean regularly with a damp towel.  Do 

not use any type of solvent for cleaning.  

Do not put too much pressure on the 

Light, Solar Panel or accessories 

while cleaning.  Dry thoroughly.

2.  WARNING!  Make sure the Power 

Switch is in its “Off” position 

before performing any inspection, 

maintenance, or cleaning procedures.

3. 

BeFoRe eaCh uSe,

 inspect the 

general condition of the tool.  Check for:
•  leaking, swollen, or cracked battery,
•  loose hardware, 
•  misalignment or binding of parts, 
•  cracked or broken parts, and 
•  any other condition that may 

affect its safe operation.

4. 

aFteR uSe,

 wipe external surfaces 

of the tool with clean cloth.

5.  Replace the battery every 12 months.  

a.  Unscrew the screws holding 

the Battery Cover (9) in place 

and remove the Battery Cover 

from the Solar Panel (1).

b.  Remove the old battery.  
c.  NiCd BATTERY MUST BE 

RECYCLED OR DISPOSED OF 

PROPERLY.   

Do not short, incinerate 

or open battery.

d.  Install a new NiCd AA, 300mAh 

battery into the Battery 

Compartment.  Check that the 

battery is placed according 

to the correct polarity. 

e.  Replace the cover and secure 

in place with the Screws.

troubleshooting

problem

possible Causes

probable Solutions

Light will 

not turn on

1.  Power Switch (7) not set to “On”.
2.  Battery not allowed time for recharging 

via Solar Panel. 

3.  Solar Light is set near nighttime 

light sources such as porch 

lights or street lights.

4.  Solar Panel is dirty and 

covered with dirt or dust.

1.  Check position of Power Switch.
2.  Check that Solar Panel has direct 

access to sunlight.  Allow one 

to two days for a full charge.

3.  Move Solar Light or change 

Solar Panel position.

4.  Clean Solar Panel with a soft cloth.

Summary of Contents for 69462









Reviews: