SKU 65026
For technical questions, please call 1-800-444-3353.
Page 8
Grip Spool Cover (1) firmly and
2.
squeeze the two tabs on the Spool
Cover.
Pull Spool Cover off Line Spool and
3.
then pull Line Spool from housing.
Make sure the Spool Spring (3) stays
connected to housing. See
Figure D
,
below.
When replacing Spool, clean any dirt,
4.
dead grass and debris from Spool
Cover.
Thread end of cutting line from re-
5.
placement spool through eyelet on
Spool Cover.
Push replacement Spool firmly onto
6.
Housing and over Spool Spring.
Fit Spool Cover over replacement
7.
spool and push down until it snaps
into place. Verify that Spool Cover is
held securely in place by the tabs.
Once new spool is in place, remove
8.
Blade Cover. Activate the Trimmer
and then the auto-feed mechanism,
which will adjust for the correct cut-
ting length.
please note:
9.
If Nylon Line breaks
while inside Spool Cover, the auto-
feed function will not work and Nylon
Line will need to be re-adjusted by
hand.
To replace broken nylon line, first
10.
follow previous steps 1-3. You will
notice a plastic band is fitted around
the Line Spool to contain the Nylon
Line.
Press down on plastic band and
11.
squeeze it off of Line Spool. See
Figure E
, below.
Recover the end of the Nylon Line
12.
and thread it through one of the two
slots on the plastic band.
Slide the plastic band over the Line
13.
Spool, making sure not to cut the
Nylon Line.
Thread the end of cutting line through
14.
eyelet on Spool Cover.
Follow previous steps 6-7 to replace
15.
Spool Cover.
Figure D
Line Spool (2)
Spool Cover (1)
Tab
Spool
Spring (3)
Figure E
Line Spool (2)
Plastic Band
