A
. Point your remote control at the Sensor and press the POWER-ON button, the REMOTE SENSOR will flash GREEN
every time it receives a command from your remote control. Your television should now be activated into standby mode.
If, at this stage, your television receives a picture, go to C below
B
. Use your remote to switch your television onto any available channel, once you see the television is active
and you have a picture on the screen please proceed to the next step.
C
. Use your remote control to switch your television off into standby mode. Power to the television and peripherals
will be cut when your television reaches a low power state, between approximately 20 seconds and 10 minutes
but may take longer in some instances.
Advanced Installation Mode
You may elect to use both the television and A/V amplifier as master devices. You must use a trailing socket to connect
to the Master Socket on the IntelliPlug and then connect the television and amplifier to the trailing socket.
DO NOT USE A 2 OR 3 WAY ADAPTER directly into the IntelliPlug.
Pairing a second Remote Control
Repeat the procedure on page 18 using the A/V remote but in stage 3, once you have released the remote sensor,
(GREEN LED is flashing once every few seconds) press and release the sensor button again.
The GREEN LED will then flash TWICE every few seconds. Then continue to complete stage 3 and 4.
Reprogramming The Sensor
To reprogram the REMOTE SENSOR you must first clear the memory. Simply PRESS and HOLD the SENSOR BUTTON
for approximately 60 seconds until the LED starts to flash RED, then release.
19
Dual Mode IntelliPlug AVC014
SECTIONS
Table of Contents
1
2
3
4
5
OPERATING THE INTELLIPLUG WITH THE REMOTE SENSOR
