NCP6925EVK
http://onsemi.com
5
SOFTWARE INSTALLATION
Double click on NCP6925_setup.exe file. Follow the
instructions set
−
up.
It is recommended to copy the NCP6925_setup.exe to a
local directory: If eval kit is already installed, a simple
double click on NCP6925.exe will launch the GUI.
Important notice: In order to properly install drivers
and software, please launch NCP6925_setup.exe file
before connects the MCU board.
Figure 4.
QUICK CONFIGURATION
Power Supply
NCP6925 requires at least 1 external power supply :
Vbat (J6) : supply between 2.5 V to 5.5 V.
Jumpers Configuration
The HWEN, A0 and A1 jumpers are configured by default
to work with the ONSEMI I
2
C interface board. GPIO1 and
GPIO2 jumpers are not configured.
S4 shunt is soldered to use only one power supply for the
DCDCs, LDOs and AVIN.
Load
DCDCx Converters
An electronic load or passive load can be connected
between J13 and J14 for DCDC1, between J15 and J21 for
DCDC2.
LDOx Regulators
An electronic load or passive load can be connected
between J16 and J14 or J21 for LDO1, between J17 and J14
or J21 for LDO2, J18 and J14 or J21 for LDO3, J19 and J14
or J21 for LDO4, J20 and J14 or J21 for LDO5.
ADC
TP13, TP14, TP18 can be used as general purpose input
for the ADC.
