ON Semiconductor MT9V117PACSTCH-GEVB, User Manual

Page: 4 / 5

MT9V117PACSTCH − GEVB
www.onsemi.com
4
Table 1. JUMPERS AND HEADERS (continued)
Jumper/Header No. Description Pins Jumper/Header Name
JP3 +1V8_VDD
1 − 2 (Default) Connects to on-board +1V8_VDD power supply
2 − 3 External power supply connection
JP4 +VDDIO_SEL
1 − 2 (Default) Sets +VDDIO to 2.8 V
2 − 3 Sets +VDDIO to 1.8 V
JP5 +VDDIO 1 − 2 (Default) Connection to on-board +VDDIO power supply
2 − 3 External power supply connection
JP6 ON_LED 1 − 2 (Default) Connects LED to indicate power on
JP7 CLK_SELECT 1 − 2 (Default) Connects to on-board 54 MHz oscillator
2 − 3 Connects to XMCLK from Demo 2X board
JP8 ATEST Open (Default) For Debug/Test
JP9 UART Control Open (Default) UART shutdown (Tri-State)
1 − 2 UART active
SW1 RESET N/A When pushed, 400 ms reset signal will be sent to MT9V117
SW2 Configuration Switch SW2.1 ON (Default) I
2
C address set to 0x90
SW2.1 OFF I
2
C address set to 0xBA
SW2.2 ON (Default) Normal Operation
SW2.2 OFF Tri-State Output
SW2.3 ON (Default) Normal Operation
SW2.3 OFF JTAG Mode
SW3 EEPROM ADDR A2 ON, A1 ON,
A2 OFF, WP ON
(Default)
EEPROM Address set to 0xA8
A0 OFF, A1 OFF,
A2 OFF, WP ON
EEPROM Address set to 0xAC
A0 ON, A1 OFF,
A2 ON, WP ON
EEPROM Address set to 0xA4
A0 ON, A1 ON,
A2 ON, WP ON
EEPROM Address set to 0xA0
Interfacing to ON Semiconductor Demo 2X Baseboard
The ON Semiconductor Demo 2X baseboard has
a similar 26-pin connector which mates with P2 of the
headboard. The four mounting holes secure the baseboard
and the headboard with spacers and screws.