![background image](http://html.mh-extra.com/html/omron/zw-c1-t/zw-c1-t_user-manual_1633390272.webp)
Connecting Parallel I/O
270
ZW User's Manual
Output cycle setting
As an example, here is an explanation of the procedure for setting the output cycle to "2 times" the
measurement cycle.
Operating procedure
GATE signal setting
As an example, here is an explanation of the procedure for setting the output time to "100 ms".
Operating procedure
Steps
Key operation
Display
Description
1 to 3
For moving to "BINARY", see steps 1 to 3 in p.264.
4
Press the
/
keys to select "CYCLE" and press the
key.
5
Set the output cycle.
The current setting value is displayed on the sub-display.
Press
key to enter the editing mode, and the sub-display blinks.
To edit numerical values, use the
/
/
/
keys.
In this example, input "2", then press the
key.
6
Press and hold the
key for two seconds to enter the RUN mode.
The measuring cycle can be viewed in the "System Information" menu.
Steps
Key operation
Display
Description
1 to 3
For moving to "BINARY", see steps 1 to 3 in p.264.
4
Press the
/
keys to select "GATE" and press the
key.
Note
Summary of Contents for ZW-C1*T
