Basic Operations for Displaying Measurement Results
44
ZW-8000/7000/5000
User's Manual
Connecting to a Personal Computer
Connect a personal computer and the Sensor Controller through an Ethernet cable to perform sensor settings
and monitoring from Sysmac Studio.
Prepare commercially available Ethernet cable satisfying the following requirements:
• Category 5e or more, 30 m or less
• RJ45 connector (8-pin modular jack)
• For direct connection: Select cross cable.
• For connection through a network hub: Select straight cable.
After connecting an Ethernet cable between the Sensor Controller and a personal computer, set the IP address which
is different from the Network address of Sensor Controller.
1
Insert one end of the Ethernet cable into the Ethernet
connector of the controller.
2
Insert another end of the Ethernet cable into the
Ethernet connector of the external device.
By default, the Sensor Controller has an IP address of 192.168.250.50 and a subnet mask of 255.255.255.0. In this
case, the network address is 192.168.250.0 and so specify 192.168.250. ** Default IP address of Sensor Controller
is 192.168.250.50 and sub mask is 255.255.255.0. Since the network address is 192.168.250.0, specify
192.168.250.** (**=2 to 254 except 50.) to the IP address of your PC. for the IP address of the personal computer.
Ethernet c
ab
le
Ethernet connector
Important
Note
Summary of Contents for ZW-7000 Series
