Omron ZG2-DSU, User Manual

Page: 62 / 91

Serial Communication
60
ZG2-DSU User’s Manual
Available Commands
Measurement value acquisition/profile acquisition commands
Bank data transfer command
Setting acquisition/change commands
Sign The sign (+, -) of the measurement value is stored.
Integer When the integer section of the measurement value is less
than 3 characters, it is prefixed with spaces for the number of
insufficient data.
When the number of digits past the decimal point
is reduced, the length of the text string decreases proportionately.
Decimal point
Digits past the decimal
point
Command
name Description Refere
nce
CFLOGGET Acquires the measurement values saved on the Memory Card. p.61
CFPRFGET Acquires the profiles saved on the Memory Card. p.63
MEASURE (or
M) Acquires measurement values set at [I/O SET]. p.64
Command
name Description Refere
nce
BKMC2CTR Transfers bank data stored on the Memory Card to the Sensor
Controller. p.65
BKCTR2MC Saves bank data on the Sensor Controller to the Memory Card. p.65
Command
name Description Refere
nce
DATAGET Acquires the setup data on the Data Storage Unit. p.66
DATASET Changes the setup data on the Data Storage Unit. p.66
DATASAVE Saves all bank data to the Data Storage Unit's flash memory. p.67
VERGET Acquires the version information system. p.67
CHGET Acquires the number of connected Data Storage Units. p.68
+12.34567 + 1 2 . 3 4 5 6 7
CR
+12.34567 + 1 2 . 3
CR
-0.00123 0 . 0 0 - 1
CR
A t meas u rement error
9 9 9 . 9 9 9 9 9
CR
-
<Measurement value> <Data configuration>
Number of digits past
the decimal point: 5
Number of digits past
the decimal point: 1
Number of digits past
the decimal point: 3