XW5T
2
Part Names and Configuration
DIN Track Terminal Block (Top Surface)
Basic Configuration
*
Do not use on the side. Two-tier Terminal Blocks with a width of 3.5
mm are excluded.
Terminal (insertion) hole
Release hole (to release
w
ire)
Label attachment section
Short Bar insertion holes
• Yo
u
can attach a Short Bar to
either of the t
w
o holes.
• Insert the tester pins here to
perform a contin
u
ity check.
Note: 1.
Do not insert more than one wire into
one terminal (insertion) hole.
2.
Do not insert more than one Short
Bar into one Short Bar insertion hole.
Name
Description
DIN Track
Terminal Blocks
Both Feed Through and Grounding Terminal Blocks are
availa
b
le.
End Cover
This part is required to prevent electric shock.
Attach one End Cover to the exposed metal surface of the
last Terminal Block or to any Terminal Block that is next to
a different shape of Terminal Block.
End Brackets
End Brackets must
b
e attached to
b
oth ends to hold the
Terminal Block in place.
Nameplate or
La
b
els
This part is availa
b
le as an accessory.
Select the most suita
b
le one for your needs.
You can also use commercially availa
b
le nameplates that
are 9.5 mm wide and 0.5 mm thick on the top.
*
Short Bar
This part is availa
b
le as an accessory.
Select one as required.
DI
N
Track
Terminal Block
End Co
v
er
End Brackets
N
ameplate or Labels
Short Bar
End Brackets
