45
CIDRW System
User’s Manual
SECTION 4
Command/Response Format
SECTION 4
Reading from/Writing to ID Tags
■
NAK
Sends the response made immediately before again.
Sends the response made immediately before again.
A response will not be returned if a NAK command is executed immediately after startup.
■
GET PARAMETER
This command gets the model number, firmware version, or another parameter.
The response code (00: normal) and received parameter value are returned.
* The contents and length of the parameter value depend on the parameter type that is specified for the command.
Command code
CR
1
2
0Dh
Command code Parameter type
CR
1
4
0Dh
Parameter Description
Parameter
Value
Description
Parameter type
01
Model number
02
Firmware version
03
MAC address
10
DIP switch enabled/disabled status
11
IP address on DIP switch
12
Subnet address on DIP switch
13
IP address in ROM
14
Subnet address in ROM
20
Memory status
21
Antenna connection status
Response
code
Parameter value
CR
0
0
0Dh
Command
Response
Command
Response
Summary of Contents for V640-HAM11-ETN
Page 14: ...12 INTRODUCTION Precautions in using the product CIDRW System User s Manual INTRODUCTION MEMO...
Page 72: ...70 SECTION 5 Window Configuration CIDRW System User s Manual SECTION 5 Browser Interface MEMO...
Page 80: ...78 SECTION 6 Troubleshooting CIDRW System User s Manual SECTION 6 Troubleshooting MEMO...