Procedure to Use Sysmac Libraries Installed Using the Installer
16
Sysmac Library User’s Manual for EtherCAT N-Smart Series Library (W549)
Procedure to Use Sysmac Librar-
ies Installed Using the Installer
This section describes the procedure to use Sysmac Libraries that you installed using the installer.
There are two ways to use libraries.
• Using newly installed Sysmac Libraries
• Using upgraded Sysmac Libraries
Version Information
To use Sysmac Libraries, you need the Sysmac Studio version 1.14 or higher.
1
Start the Sysmac Studio and open or create a new project in which you want to use Sysmac
Libraries.
Precautions for Correct Use
If you create a new project, be sure to configure the settings as follows to enable the use of
Sysmac Libraries. If you do not configure the following settings, you cannot proceed to the step
2 and later steps.
• Set the project type to Standard Project or Library Project.
• Set the device category to Controller.
• Set the device version to 1.01 or later.
Using Newly Installed Libraries
Summary of Contents for SYSMAC-XR005
