7
.
EtherCAT Connection Procedure
13
7.3. Controller Setup
Set up the Controller.
7.3.1. Starting Sysmac Studio and Installing the ESI File
Start Sysmac Studio and install the ESI file of the Dry Vacuum Pump.
1
Make sure Dry Vacuum Pump
and Power supply for Controller
are OFF.
2
Connect PC and Built-in
EtherNet/IP port (PORT1) on
Controller with a LAN cable.
Connect the other end of the
Ethernet cable (which at one
end has been connected to Dry
Vacuum Pump) to Built-in
EtherCAT port (PORT3) on
Controller.
Connect Power supply to
Controller.
*For information on the power
supply connection to Controller,
refer to
5-4-1 Wiring the Unit
Power Supply
of the
NX-series
NX102 CPU Unit Hardware
User's Manual
(Cat. No.
W593).
3
Start Sysmac Studio.
*If the User Account Control
Dialog Box appears at start,
make a selection to start
Sysmac Studio.
4
Sysmac Studio starts up.
Click
New Project
.
Ethernet cable
Built-in EtherCAT port
(PORT3)
Built-in EtherNet/IP port
(PORT1)
Controller
LAN cable
Power
supply
PC
Dry Vacuum Pump
Summary of Contents for sysmac EtherCAT NJ101 Series
Page 33: ...30 ...
Page 34: ...2021 0621 0621 P745 E1 01 ...