195
Temperature Input Units
Section 6-4
4. Select the tab page for the input where top/valley hold is to be set, and se-
lect the
Top/Valley Hold
Check Box in the
Function Choice
Area.
5. To allocate the Hold Flag (output) in the default connection path, click the
General
Tab, and select
Holding Value
from the pull-down menu in the
Default Connection Path (Out)
Field.
6. Click the
Download
Button to execute the download procedure, and then
click the
OK
Button to return to the Edit Device Parameters Window.
7. Return to the
General
Tab Page, click the
Download
Button, and then
click the
Reset
Button to reset the Unit.
8. Click the
OK
Button to exit.
Hysteresis Setting
The hysteresis value can be set using the Configurator to prevent detection of
top or valley values that occur due to minor fluctuations in the temperature
input value. This will cause the start of data holding to be delayed after the
actual top or valley value occurs, as shown in the following diagram.
Summary of Contents for SMARTSLICE GRT1-DRT
