![background image](http://html1.mh-extra.com/html/omron/r88d-1snx-ect-series/r88d-1snx-ect-series_startup-manual_744171024.webp)
24
3.2. System configuration with NJ and NX safety controller
■ Ethercat node address configuration
1.
Please configure the Ethercat node address of the drive to 1.
Note: You can configure the node address depending on your application
2.
In case of using NX safety, please configure the node address of the NX coupler to
2.
Note: You can configure the node address depending on your application
3.
Please connect EtherCAT cables to devices
CN10 Ethercat IN: Ethercat cable from NJ EtherCAT Master
CN11 Ethercat OUT: Ethercat cable to NX coupler unit
Additional Information
For further details about safety controller, please refer to the NX-series safety control
units user manual Z930
Summary of Contents for R88D-1SNx-ECT Series
Page 17: ...17 2 Approach the drive from top to down 3 Tight the upper part 4 Tight the down part...
Page 38: ...38 6 Add the Emergency stop button 7 Add the Reset button 8 Edit I O Map variables...
Page 58: ...58 11 Results Wizard step 5 Save to EEPROM Finish...
Page 59: ...2016 0616 0616 I823 E1 01 Note Do not use this document to operate the Unit...