![background image](http://html.mh-extra.com/html/omron/omnuc-g5/omnuc-g5_user-manual_742230395.webp)
8-30
8-4 Analog Control Parameters
OMNUC G5-SERIES AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
8
Parameters Details
When the zero speed designation input is turned ON and the speed command is less than the
Position Lock Level Setting (Pn316), the operation switches to position control and servo locks.
When the zero speed designation input is turned ON, the speed command will never be 0. You
need to change the speed command.
Since the operation is executed as a normal position control during position control, properly set
the position loop gain, various error detection functions and other settings.
Use this parameter when the CONTROL mode Selection (Pn001) is set to 1 (speed control).
This may not operate correctly if the CONTROL mode Setting (Pn001) is set to 3 (position or speed
control) or 4 (position or torque control).
Servo locks with position control when the speed of the motor is lower than the setting of this
parameter.
The setting of this parameter is valid for both forward and reverse direction regardless of the motor
rotation direction.
ON
Speed command
Position control
Position control
Speed control
Pn316
Zero speed designation input
Figure C
Pn316
Position Lock Level Setting
Setting
range
10 to 20,000
Unit
r/min
Default
setting
20
Power OFF
and ON
−
Speed Torque
Speed
Reverse operation
Speed
control
Servo lock
(Pn316)r/min
Forward operation
(Pn316)r/min
Speed
control