Omron NY532-1*00-111*13**0, User Manual, Page: 127 / 214

5-3-3
Temperature
The temperature inside a control panel may be at least 10 to 15°C higher than outside the panel. Im-
plement the following measures against overheating at the installation site and in the control panel,
and allow a sufficient margin for the temperature.
Distance for Cooling
Adequate airflow around the Industrial Panel PC is required.
Additional Information
• The ambient temperature must be within the operating range.
Refer to 4-4-1 Operation Environment Specifications on page 4 - 23 for temperature specifi-
cations.
• Allow space to accommodate for the bending radius of the cables.
Refer to:
•
3-9-4 DVI Cables on page 3 - 24
• 3-9-5 USB Type-A to USB Type-B Cables on page 3 - 24
• 3-9-6 NY Monitor Link Cables on page 3 - 25
• individual cable specifications
for cable bending requirements and connector clearance.
and to
3-9-5 USB Type-A to USB Type-B Cables on page 3 - 24 for USB cable bending re-
quirements.
Provide enough space for good air flow and ensure the following minimum distances are observed
around the sides of the IPC Machine Controller for landscape A and portrait B orientations.
A
B
B + A
X X
X X
Y
Y
Y
Y
Z
Item
Minimum distance
*1
X 50 mm
Y 100 mm
Z
*1. Measure the minimum distances X and Y at the air openings in the sides of the IPC Machine Controller.
5 Installation
5 - 15
NY-series Industrial Panel PC Hardware User's Manual (W557)
5-3 Mount
5
5-3-3 T
emperature