3-1
Installing Units
The NX-series Safety Control Units are installed in the same way as the NX Units. This section de-
scribes how to install and remove NX Units and how to attach markers.
Refer to the user's manual of the NX bus master, that the Safety Control Unit is to be connected to, for
details on preparations for installation, installation in a control panel, etc.
3-1-1
Installing NX Units
This section describes how to mount two NX Units to each other.
Always turn OFF the power supply before you mount NX Units.
Always mount NX Units one at a time. If you attempt to mount multiple NX Units that are already con-
nected together, the connections between the NX Units may separate from each other and fall.
Precautions for Safe Use
• Do not apply labels or tape to the Unit. When the Unit is installed or removed, adhesive or
scraps may adhere to the pins in the NX bus connector, which may result in malfunctions.
• Do not touch the pins in the NX bus connector on the Unit. Dirt may adhere to the pins in the
NX bus connector, which may result in malfunctions.
Example: NX Unit (12 mm width)
NG
NG
• Do not write on an NX Unit with ink within the restricted region that is shown in the following
figure. Also do not get this area dirty. When the Unit is installed or removed, ink or dirt may
adhere to the pins in the NX bus connector, which may result in malfunctions in the CPU
Rack or the Slave Terminal.
Refer to the user’s manual for the connected CPU Unit or Communications Coupler Unit for
the restricted region of CPU Unit and Communications Coupler Unit.
Restricted
region (shaded
portion)
3 Installation and Wiring
3 - 2
NX-series Safety Control Unit User's Manual (Z930)
Summary of Contents for NX-SIH400
