4
3. Taking a Measurement
Measurement should be taken on a level and hard surface.
1.
Tap the parts below
the right and left
sides of the platform
to turn on the power,
then lift your foot away from the
platform.
are displayed.
Note:
If you leave your foot there, the
measuring is not going to be precise.
2.
When
is displayed, step onto
the scale.
The measurement starts. The result will be
shown when
are
displayed in sequence.
Notes:
• If you step onto the scale before
appears on the display, correct measurement
will not be possible.
• The scale will automatically turn off 10
seconds after
is displayed.
3.
Check the measurement results.
The scale will be turned off automatically after 6
seconds.
Note:
If the result is still unstable when
are displayed,
it will continue to cycle the display
till
measurement is stabilized and the
result is displayed. But if this process
lasts more than 10 seconds, and no
result is displayed, the scale will be
turned off automatically in 3 seconds
after Err is displayed.
4. Error Displays
5. Troubleshooting
Error Display
Cause
Correction
The weight is out of the weighing range
(more than 150 kg).
You did not lift your foot off the platform
after the power is just tapped on.
Lift your foot off first when the power is just
turned on.
Problem
What to Check
Correction
Power can not be tapped on
Is the scale placed on ground level? Please place it on a level and hard
surface for use.
Battery power may be low.
Please replace batteries.
Are the batteries wrongly inserted?
Please insert the batteries as
illustrated in section 2. “Inserting
and Replacing the Batteries”.
Abnormal results are displayed
Is the scale placed on ground level? Please place it on a level and hard
surface for use.
Was your foot still on the platform
after you switched on the scale by
tapping?
Please lift your foot away from the
unit immediately after you switched
on the scale by tapping. (Refer to
“3. Taking a Measurement”)
Care and maintenance
