Omron GigE Vision STC-SBS163POE, Product Specifications And User'S Manual

Page: 46 / 53

No.14S002-08
46/53
STC-SBE132POE / STC-SCE132POE
Product Specifications and User’s Guide
AcquisitionControl
Name Description
AcquisitionMode Sets the acquisition mode of the device. It defines mainly the number of frames to
capture during an acquisition and the way the acquisition stops.
AcquisitionStart Starts the Acquisition of the device. The number of frames captured is specified by
AcquisitionMode.
AcquisitionStop Stops the Acquisition of the device at the end of the current Frame. It is mainly used
when AcquisitionMode is Continuous but can be used in any acquisition mode.
AcquisitionFrameCount Number of frames to acquire in MultiFrame Acquisition mode.
AcquisitionFrameRate Controls the acquisition rate (in Hertz) at which the frames are captured.
TriggerSelector Selects the type of trigger to configure.
TriggerMode Controls if the selected trigger is active.
TriggerSoftware Generates an internal trigger. TriggerSource must be set to Software.
TriggerSource Specifies the internal signal or physical input Line to use as the trigger source. The
selected trigger must have its TriggerMode set to On.
TriggerActivation Specifies the activation mode of the trigger.
TriggerDelay Specifies the delay in microseconds (us) to apply after the trigger reception before
activating it.
ExposureMode Sets the operation mode of the Exposure (or shutter).
ExposureTime Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
ExposureTimeAbs Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
ExposureTimeRaw Sets the Exposure time when ExposureMode is Timed and ExposureAuto is Off. This
controls the duration where the photosensitive cells are exposed to light.
ExposureAuto Sets the automatic exposure mode when ExposureMode is Timed. The exact algorithm
used to implement this control is device-specific.
DigitalIOControl
Name Description
LineDebounceTime Sets the value of the input line debouncer time.
LineSource0 Set the output signals from the power / IO connector.
LineSource1 Set the output signals from the power / IO connector.
UserOutputValue0 Sets the value of the bit selected by LineSource0.
UserOutputValue1 Sets the value of the bit selected by LineSource1.
StrobeSignalDelay Specifies the delay in microseconds (us) to apply the trigger reception before activating
strobe signal.
StrobeSignalOnTime Specifies the strobe signal active time in microseconds (us).
LineInverter0 Controls the invertion of the signal of the selected output line of LineSource0.
LineInverter1 Controls the invertion of the signal of the selected output line of LineSource1.
Aegis Electronic Group, Inc.
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com