6
F3E
Multibeam sensor
Precautions
Power Supply Voltage and
Output Load Power Supply Voltage
Do not connect an AC power supply to the Sensor. If AC pow-
er (100 VAC or more) is supplied to the Sensor, it may ex-
plode or burn. Make sure that the power supply to the Sensor
is within the rated voltage range. If a voltage exceeding the
rated voltage range is supplied to the Sensor, it may explode
or burn.
Operating Environment
Do not use the Sensor in locations with explosive or flamma-
ble gas. Make sure that the product is operated in accordance
with IP54 standards.
Do not subject the multi-beam sensor to excessive shock
when mounting.
When you use the multi-beam sensor in the vicinity of an in-
verter motor, be sure to connect the protective earth ground
wire of the motor to earth. Failure to ground the motor may re-
sult in malfunction of the sensor.
Mounting the Sensor
Do not strike the Photoelectric Sensor with a hammer or any
other tool during the installation of the Sensor.
Cleaning
Never use paint thinners or other organic solvents to clean the
surface of the product
M8 Connector
Always turn OFF the power supply to the Sensor before con-
necting or disconnecting the metal connector. Hold the con-
nector cover to connect or disconnect it.
Secure the connector cover by hand. Do not use pliers; other-
wise the connector may be damaged.
If the connector is not connected securely, it may be discon-
nected by vibration or the proper degree of protection of the
Sensor may not be maintained.
@
WARNING
The F3E multi-beam photoelectric sensor is not a
safety component for ensuring the safety of people
which is defined in EC directive (2006/42/EC) or by
any other regulations or standards.
In the interest of product improvement, specifications are subject to change without notice.
Cat. No. E48E-EN-01A
OMRON EUROPE B.V.
Wegalaan 67-69,
NL-2132 JD, Hoofddorp,
The Netherlands
Phone: +31 23 568 13 00
Fax:
+31 23 568 13 88
www.industrial.omron.eu
