12. Appendix
12-20
As described above, only the channels that are registered to the EQ project can be viewed on
the Web UI screen. A graph cannot be viewed for a channel for which collected data are saved
in EQ100 but which is not registered to the EQ project.
Failure and Replacement of Measurement Device
12.4.1.
When a measurement device is replaced due to a failure, measured data before the failure can
be migrated by using a measurement device with the same model as that of the failed
measurement device. In such a case, you do not need to register a new measurement device to
the EQ project.
Note that the settings of the measurement devices failed and to be replaced must be the same.
Precautions for
Correct Use
- If integrated values are measured, always clear the previous values of integrated data before
starting data collecting. Otherwise integrated data cannot be properly acquired right after
starting the collecting.
Support for New Measurement Device
12.4.2.
To use a measurement device for EQ100, use the latest EQ-Manager.
For the latest EQ-Manager and support for measurement devices, see OMRON's site: