3. Check and Preparation
3-13
Note
・
Air Flow Station units are assigned by the IP address: 192.168.0.20, and subnet mask:
255.255.255.0 as the factory defaults.
・
The IP addresses of Air Flow Station units and the PC must be individually unique and
must not overlap one another in the network. In the example above, Air Flow Station
Unit 2 is assigned with "192.168.0.21", the PC, "192.168.0.100", changing the fourth
value (segment) of the IP address of the Air Flow Station Unit 1, in order to distinguish
among the units connected.
・
Set the same subnet mask value to both the Air Flow Station units and PC to be
connected in the network.
・
To change the subnet mask, contact your network administrator.
If the subnet mask is changed from 255.255.255.0, the fourth segment of the IP
addresses of the Air Flow Station units and PC in the network still must be distinguished
from one another.
・
The setting range of the individual segments of IP address and subnet mask is 0 to 255.
3.6.2 Setting Air Flow Station IP Address
This section explains the procedure to set the IP address for Air Flow Station Unit 2
(Example: Change the factory default "192.168.0.20" to "192.168.0.21").
Note
Refer to the sections "2.1 Display Unit" and "2.2 Control Unit" for details on messages
displayed on the display unit and operational key functions.
(1)
Switching to "FUN" Mode
To change the IP address, press the MODE key until the "FUN" indicator at the right of the
display starts blinking.
RUN mode
FUN mode
“FUN” blinks
THR mode
MODE key
twice
MODE key
MODE key