67
Wiring and Connections
Section 3-4
3.
Assemble the socket and connector as shown in the following diagram.
3-4-5
Using Terminal Blocks
We recommend using the following Terminal Blocks to wire devices to the
CPM2C-S’ I/O connector. Refer to
for details on
I/O wiring.
Note
The allowable current for the XW2Z-
@@@
A is 1 A. Do not allow the current on
the common terminal to exceed 1 A.
3-4-6
Connecting I/O Devices
Wire inputs and outputs to the CPM2C-S’ CPU Unit as shown in the following
diagrams.
Connector cover
Socket
Nuts (3)
Nuts (2)
Connector screws
Small screws (2)
Cable clamp
Small screws (3)
I/O
XW2Z-
(((
A Cable
Terminal Blocks
XW2B-20G4 (M3 screws)
XW2B-20G5 (M3.5 screws)
XW2D-20G6 (Thin version)
Summary of Contents for CPM2C-S100C
