178
Programming Console Operations
Section 8-2
After completing the insertion and deletion procedures, use the Up and Down
Arrow Keys to scroll through the program and verify that it has been changed
correctly, as shown in the following diagram.
8-2-13 Checking the Program
This operation checks for programming errors and displays the program
address and error when errors are found. It is possible in PROGRAM mode
only.
1,2,3...
1.
Press the CLR Key to bring up the initial display.
2.
Press the SRCH Key. An input prompt will appear requesting the desired
check level.
3.
Input the desired check level (0, 1, or 2). The program check will begin
when the check level is input, and the first error found will be displayed.
Note
Refer to
for details on check levels and the
errors that may be detected when the program is checked.
4.
Press the SRCH Key to continue the search. The next error will be dis-
played. Continue pressing the SRCH Key to continue the search.
The search will continue until an END instruction or the end of Program
Memory is reached. A display like this will appear if the end of Program
Memory is reached:
A display like this will appear if an END instruction is reached:
If errors are displayed, edit the program to correct the errors and check the
program again. Continue checking the program by pressing the SRCH Key
again until all errors have been corrected.
00104
00100
00105
00101
00201
END(01)
00102
01000
Corrected Program
Address
Instruction
Operands
00205
AND
00105
00206
AND NOT
00104
00207
OUT
01000
00208
END(01)
-
RUN
MONITOR
PROGRAM
No
No
OK
SRCH
00000PROG CHK
CHK LBL
(0-2)?
A
0
00178CIRCUIT ERR
OUT
00200
SRCH
00300NO END INST
END
SRCH
00310PROG CHK
END (001)00.3KW
No more errors exist if the END
instruction is displayed.
Summary of Contents for CPM2C-S100C
