![background image](http://html.mh-extra.com/html/omron/c200hw-clk21/c200hw-clk21_operation-manual_742483342.webp)
317
Error Log
Section 9-3
Error Status
The status of each bit indicates that an error has occurred as given in the dia-
gram below.
9-3-3
Reading and Clearing Error Logs
Error logs can be read or cleared using the Controller Link Support Software,
the CX-Programmer, PLC Programming Devices, or the message service.
The following examples are for the Controller Link Support Software and the
message service. When using a PLC Programming Device, refer to the Pro-
gramming Device’s operation manual for details.
Controller Link Support Software
Read or clear the error log using the following procedure.
1,2,3...
1.
Display the Main Menu.
2.
Select “E: Error log.”
3.
Designated the node. The error log for the designated node will be dis-
played.
4.
Press the F7 (Clear) Key. The designated node error log will be cleared.
Right-click the target PLC in the Network Configuration Window and select
Error Log of Communication Unit
from the pop-up menu.
The Error log Dialog Box will be displayed. In this example, a Controller Link
Unit is selected.
1: Token timeout error
1: Polling timeout error
1: Communications controller hardware error
1: Polling node was changed
1: Nodes in Network changed (added or removed)
1: Communications controller send error
1: Node address duplication error
Summary of Contents for C200HW-CLK21
