２
Installation
2-1 Rackmount installation
(EIA/JIS 19-inch rack/server rack)
BUM150RA
16
２
Installation
2-1 Rackmount installation
(EIA/JIS 19-inch rack/server rack)
Install on the EIA/JIS19 19-inch rack/server rack.
Caution
When performing rack installation, ensure that the UPS is
supported and stabilized by using both the support angles and
the table clamps that were included.
When installing on a rack, make sure that the UPS is supported by the
each unit individually.
When installing on a rack, make sure to use the support angles and table
clamps included with the product. Without the support angles, the front
clamp alone cannot support the weight of the UPS.
The mass of each unit: Approx. 31kg
In a case where the UPS is to be mounted on a rack, place it on
the low part of the rack.
Dropping it may result in injury.
Be sure to use the supplied mounting screws.
Use of long screws other than those supplied for case mounting may
damage inside the unit.
Screws other than those supplied may not be strong enough to support
the UPS, causing it to fall.
■
Items included in the 19-inch rack support angle set
Rack rail (front) L
1
Rack rail (front) R
1
Rack rail (rear)
2
Ear brackets
2
Rack fixing screws (8 x M4)
4
Ear bracket flush mounting screws (6 x M3)
8
EIA/JIS Rack fixing screws (16 x M5)
10
JIS Rack fixing flush mounting screws (14 x M5)
2
EIA rack fixing nuts (M5)
10
