HS-360X Four-Slot Spare Battery Charger Quick Start Guide
5
Mounting the Charger
To mount the charger on a vertical (wall) surface:
1.
Connect the power cable to the power port and an AC power source. Insert
the power cable into the cable groove.
2.
At the desired location, mark the location of the screws holes. The distance
between the two mounting screw holes is 103 mm. The gap between the wall
and the screw head is approximately 2.5 mm.
3.
Pre-drill holes to accommodate two screws.
4.
Attach the charger securely to the surface.
5.
Insert up to four batteries to charge.
Inserting Batteries
To insert batteries in the battery charger, angle the battery with the contacts facing
up and slide the contact side of the battery under the LED indicator ledge as
shown below. Push down on the label surface of the battery until it clicks in place,
engaging the contacts in the battery charger.
Removing Batteries
To remove batteries from the charger, pull the battery out of the battery well from
the top of the battery.
Charging Batteries
To insert batteries in the battery charger, angle the battery with the contacts facing
up and slide the contact side of the battery under the LED indicator ledge as
shown below. Push down on the label surface of the battery until it clicks in place,
engaging the contacts in the battery charger.
